Xprite LED Tail Lights for Jeep Wrangler JK JKU 2007-2018 - Brake & Turn Signals - Off-Road & Night Driving

I wasn't very happy with the installation of these lights. They are secured to my Jeep, but aren't flush with the body panels. I had to get Gorilla Tape to cover the gap between my rear fender and the light. The lights are very bright though and are a definite improvement over the stock crap that comes from the factory. LEDs are the best way to go. These are bright and clear but I can't say that I'd recommend them just due to the fit.These are great! I saw them on an other jeep and had to have them. The plastic is nice and solid. It doesn't feel like it'll break very easily. The install was super easy. I got it done in 10 minutes. The brightness is better than the stock lights.They installed great and looked awesome until the next morning when the inside was full of condensation. And pretty much every morning since installing them. BQuick installHave to use old screwsFogs up time to timeThe right like flickers when closing trunkLove the lookI debated for a few weeks if I needed these or not because I thought the stock tail lights looked just fine but I’m so happy I did! These added such a tough look to the back of my Jeep, and the install couldn’t have been any easier. Don’t hesitate like I did, you won’t regret it!Fast delivery and easy to installLooked good but sadly both leaked water and LED started dropping out. In fairness to the seller I did not even bother to try and return but would not buy again. Spent the money on new quality name brand and now happy.Update:So seller contacted me and I am changing my review. Without hesitation offered me new lights or full refund. I am not going to lie totally blown away by the service and my bad for not giving them an opportunity to make it right. Thank you so much !!!! Stand up company A+++++++This LED tail light is good for the price but has two major flaws that I managed to come up with a solution for:1- The clips for holding the resistor fixture are loose and hence the resistors fall every time you drive on a bump.How did I fix it? Well, luckily there are a few small holes on the back side of this light fixture that two of those holes are perfectly positioned to align with the resistors holes. You can fasten the resistor directly onto the back side of these lights using the tiny screws provided. (See attached photo).2- The enclosure is NOT sealed or water tight by any means. Moisture permeates through the enclosure and condenses to form water droplets inside the LED enclosure. To fix this problem I applied a layer of silicon sealant onto the edges and the wire feed-through holes. I haven’t had moisture building up inside the unit so far. (see attachment)So the product arrived on time and it does work. However, the wiring connections are not good quality. I had to buy an additional resistor because both wires disconnected on me. As I checked other connections, they were very sketchy. I had to tape all connections And now have to wait for the new resistor to come in before I can install. Hopefully it will work! Additionally, the fit is not as tight against the body as the stock ones.Amazing look, easy install, however I noticed some water in light and also humidity build up.... Won't go away even if it's a very hot sunny day.... Also noticed on the other side.... Sent message and awaiting reply...Came in a smashed up box but was covered in a new box and one of the resister wires was broke had to go to hardware store and buy sodering tools to fix it. Plastic is smaller than OEM so if your running trail armor it might have large gap around it .